PLC Control Wall Angle Channel Roll Forming Machine Total 13 Forming Stations
Technical Parameter
Material of coil |
Material Thickness |
0.4-0.8 mm galvanized sheet G550 |
Forming system |
Rolling Speed |
About 20 m/min line speed |
|
Roller Stations |
About 13 stations |
|
Roller Material |
45# Steel with quenching 60mm shaft
|
|
Maim Motor Power |
5.5 kw |
|
Hydraulic cutting Power |
4 kw |
Cuttingsystem |
Material Of Cutting |
CR12 with quench treatment |
|
Hardness |
HRC58-62 |
|
Tolerance |
+-1.5mm |
Electrical control system |
Electric Source |
380V, 50HZ,3 phase Also can satisfy Customer’s require |
|
Control System |
PLC control system |
|
Weight |
About 2.5 tons |
|
Way Of Drive |
1 inch single chain |
|
Size of machine |
Length 4500mm* Width 500mm* Height 800m |
Work Flow Chart
Decoiler—feedingwithguide—Rollforming——Cutting—Products collecting
Machine Components
3 ton passive de-coiler |
1 set |
Main roll forming machine |
1 set |
PLC Control box |
1 unit |
Hydraulic station |
1 unit |
Out table |
2 units |
Following cutting |
1 unit |
Safety cover |
1 unit |
Machine Photo
Contact Us at Any Time