|Profile Width:||100-600mm||Material Thickness:||1-2mm Galvanized Coils|
|Profile Height:||50-100mm||Uncoiler:||10 Ton Passive|
|Punching Way:||Hydraulic Punching 3 Set||Rolling Speed:||3-5 M/min|
|Roller Stations:||20 Stations|
metal forming machine,
plate rolling machine
1-2mm Galvanized Steel Chain Drive Economic Cable Tray Roll Forming Machine Hydraulic Punching
A cable tray system, is "a unit or assembly of units or sections and associated fittings forming a rigid
structural system used to securely fasten or support cables and raceways." Cable trays are used to hold
up and distribute cables. Cable tray roll forming machine is special designed for its production.
Specifications of cable tray machine :
|05||Forming Speed||10M/Min Max|
1 Drive decoiler
Material inner diameter:460-510mm
Material outer diameter:1500mm
Drive power: electromotor and speed reducer integration, 4kw frequency conversion electromotor
Frame type: cantalever inner support, manual handle afterbody, pneumatic press cantalever.
Working rolls: 11 rolls, up 4/down 5, the residual 2 rolls is clamp deliver rolls.
Flatting bound: material thickness 12mm, material width 100-860mm
Drive power: 5.5kw frequency conversion electromotor
Speed reducer model: ZQ250
flatting speed:310 m/min
Parenthesis up and down a pair of fortified wheel
3 Continual punching mould
Amount: Each kind of width specification 1 set dies, total 6 sets
Die require: Cr12 quenching
4 Servo feeding set
Servo electromotor power: 4kw
Multistage type feeding, memory ten group of memory functions
Man-machine contact surface numerical control system
Uses Mitsubishi servometer
5 Holds material (use in cushion section)
The roller type, the both sides have the bearing support, 3 sets, use in holding the material and under the deposited material spacing.
A pair of horizontal roller and two pairs of vertical guide rolls, total 1 sets.
7 Main roll forming machine
forming frame: 16 sets
Forming variety: bridge frame
material max width:600mm
material max thickness:≤2.0mm
forming width: 100-600mm
forming height: 50-200mm
The diameter of the roller axis: 85mm
Roll mould material: Gcr15,quenching treatment:HRC58-62°
Drive type:30kw frequency conversion electromotor, ZQ500 Main speed reducer
Autocephaly distribute gear case
8. Hydraulic cutting
Hydraulic pumping station: 5.5kw
blade cuttimg, blade material Cr12, quenching treatment
Working Flow of Roll Forming Machine
Uncoiler—Feeding—Leveling—Punching&Cutting—Roll forming—Output table
Profile drawing of cable tray
1. Installation and training of light keel making machine:
a.If buyers visit our factory and check the machine, we will teach you how to install and use the machine,
and also train your workers/technician face to face.
b.Without visiting, we will send you user manual and video to teach you to install and operate.
C.If buyer needs our technician to go to your local factory, please arrange board and lodging and other
2. After Service of light keel making machine
a.One year guarantee for whole machine.
b.24 hours technical support by email or calling
c.If there is any problem found of light keel making machine, we will repair it for free in one year.
Contact Person: Miss. Spring Wu